Compatible Multi Protocol, Support TELEM, 2.4G Micro 5Channel Receiver Built-in 1S 5A Brushled ESC CROSSOVER-RX RX62 Series Receiver

Verfügbarkeit: 100 auf Lager
Artikelnummer: XFX_MXO_RX62
*

Compatible 2.4G radio control protocol

$14.00
Versand an
*
*
Versandart
Name
Voraussichtliche Lieferung
Preis
Keine Versandoptionen

Compatible Multi Protocol, Support TELEM(with "+"Version), 2.4G Micro 5-Channel Receiver  Built-in 1S 5A Brushed ESC,  Work Votage: 3-5V, Size: 16.3(L) X 10(W) X 2.5(H) mm. If CH4 connected to GND, CH1 will be output PPM signal.

About the compatible protocols, note the suffix of the receiver

With A is compared  with AFHDS(A1)or AFHDS-2A(A2)protocol of FlySky , With D is compatible with DSMX/2 protocol of Horizonhobby , Spektrum etc. With F is compatible with D8 (F1) or D16 (F2) protocol of Frsky, With H is compatible with the protocol of HUBSON,  With S  is compatible with S-FHSS protocol of Futaba.  Please select the appropriate receiver according to your transmitter protocol.

 Binding: The receiver goes in binding mode automatically after powered on and no signal for 15 seconds (slow flashing LED light turns to fast flashing), then complete the binding operation according to your transmitter binding manual. LED of receiver is on and binding is completed.

The TELEM function: it can realize the real-time monitoring of battery voltage, receiver working voltage, receiver signal strength and receiver working temperature. It also needs the supportion of transmitter, so that you can master the working status of receiver and battery in real time. Note: the distance of the TELEM function is related to the transmitter. It is normal that the working distance of the receiver is much higher than the TELEM function.

Start-Lock Function: It can prevent brushed motor starting by mistake.  For example the throttle stick is not at the lowest position when the receiver is powered on.When the throttle stick  is at the lowest position for 2 seconds, as soon as the receiver gets the signal, Start-Lock will be released then, the brushed motor can work when the throttle stick is pushed.

Back

Interface, There are many negative electrodes,  at PWM mode, CH1---AIL, CH2---ELE, CH3---THR, CH4---RUD, CH5---AUX1

When the receiver loses the control signal, the throttle (CH3) will clear 0 (value is 850), ch1-ch2-ch4 will return to center (value is 1500), and the output of other channels will remain unchanged

Size

Compared with the  82 series, it is a little narrower and longer

It is about  0.46g